1.1 Output: Continues 18A, Burst 22A up to 10 Secs.
1.2 Input Voltage: 5.6V --- 16.8V ( Lithium : 2 ¨C 4s or NiMH/NiCd 5 -12 Cells)
1.3 BEC (Battery Elimination Circuit) Output£ºlinear mode BEC 2A
1.4 Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BLM. (BLM: BrushLess Motor)
1.6 Weight: 19g
2.1 Safety Arming Feature: Regardless the Throttle Stick position, the motor will not spin after battery connected. This will prevent any injury happened.
2.2 Throttle Calibration: Throttle range can be configured to provide best throttling linearity, fully compatible with all market available transmitters.
2.3 Programmable Items:
¡ñBrake Settings£ºbrake enabled / brake disabled, default is brake disabled
¡ñBattery Type£ºLi-xx(Li-ion or Li-poly) / Ni-xx(NiMh or Nicd)£¬default is Li-xx.
¡ñLow Voltage Protection Mode(Cutoff Mode) £ºpower reducing / power cutoff, default is power reducing.
¡ñLow Voltage Protection Threshold(Cutoff Threshold) £ºlow / medium / high, default is medium cutoff voltage.
1)For Li-xx battery£¬number of battery cells are judged automatically£¬low / medium / high cutoff voltage for each cell are: 2.6V/2.85V/3.1V. For example: 3 Cells Li-Poly, when medium cutoff voltage is set, the cutoff voltage is: 2.85*3=8.55V.
2)For Ni-xx battery, low / medium / high cutoff voltages are 0%/45%/60% of the startup voltage (0% means the low voltage cutoff protection function is disabled) . For example: a 10 cells NiMH battery pack, fully charged voltage is 1.44*10=14.4V, when medium cutoff voltage is set, the cutoff voltage is : 14.4*45%=6.5V
¡ñStartup mode: normal / soft / super-soft, default is normal startup.
¡ñTiming: low / medium / high, default is medium timing. In normal cases, low timing can be used for most motors. But for high efficiency, we recommend the Low timing for 2 poles motor and Medium timing for 6 poles and above. For higher speed, High timing could be used.
2.4 Full Protection Features: Low-voltage cutoff protection / over-heat protection / throttle signal lost protection.
3.1 Military Standard Capacitor with extremely low resistance used on voltage input section, this will increase the ability of prevention of unwanted RF Noise/ Interference during flying.
3.2 Extreme low resistance, super current endurance.
3.3 Microprocessor and BEC use separate voltage regulator IC, with good anti-jamming capability.
3.4can easily be adapted to twin balance ESC for double engines jet